Cd-R Release Lever Sub Assy; Reinstalling The Paper Ej Frame Assy; Removing The Right Cd-R Release Lever Sub Assy - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400
Hook both rear ends of the Paper EJ Frame Assy onto
the Tabs on the Main Frame.
Align the Bearing of the CD-R Release Level Sub Assy
with the Paper EJ Release Shaft.
Shaft and
Bushing
Figure 4-85. Reinstalling the Paper EJ Frame Assy.
Match the Tabs with the five Positioning Holes.
See Figure 4-83.
Tighten the screws in the order shown in
A D J U S T M E N T Be sure to perform the following adjustments when the Paper
R E Q U I R E D
EJ Frame Assy is replaced or removed:
1. Ink Mark Sensor Adjustment
2. PW Sensor Adjustment
3. PF Adjustment
4. PF Adjustment (Bottom Margin)
Refer to Chapter 5 "Adjustment" for details of the
adjustments.
Disassembly And Assembly
Shaft and
Bushing
Tabs
Figure 4-84.
Disassembly

4.2.6.7 CD-R Release Lever Sub Assy

1. Remove the Printer Mechanism.
2. Remove the Paper EJ Frame Assy.
3. Remove the Shaft on the Right CD-R Release Base from the Bushing on
the CD-R Release Lever.
Right CD-R Release Base
Figure 4-86. Removing the Right CD-R Release Lever Sub Assy (1)
4. Remove the C.B.S. M3 x 6 screw that secures the Right CD-R Release
Lever Sub Assy.
2) C.B.S. 3x6
(6±1 kgf.cm)
Figure 4-87. Removing the Right CD-R Release Lever Sub Assy (2)
Revision B
See Section 4.2.1.5 on page 78.
See Section 4.2.6.6 on page 105.
Shaft and Bushing
CD-R Release Lever
106