Adding An Encryption Target - Brocade Communications Systems WFT-2D User Manual

20
Configuring encryption storage targets
5. Confirmation
6. Configuration Status
7.

Adding an encryption target

1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the
FIGURE 367
3. Click Add.
812
Important Instructions
dialog box. (Refer to Figure 266
target, then select Group/Switch/Engine > Targets from the menu task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to
Encryption Targets dialog box
The Configure Storage Encryption wizard welcome screen displays. (Refer to
on page 694.)
Figure
Brocade Network Advisor SAN User Manual
367.)
Figure 368.)
53-1003154-01