Manager (Dpm) - Brocade Communications Systems WFT-2D User Manual

8. Select the Key Vault Type. Configuration options vary based on the key vault type you choose.
Configuring key vault settings for RSA Data Protection Manager (DPM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 764.
Figure 318
FIGURE 318
Brocade Network Advisor SAN User Manual
53-1003154-01
To complete the wizard steps, proceed to the section that describes your particular key vault
type.
-
For DPM key vault setting instructions, see
Protection Manager (DPM)"
-
For LKM/SSKM key vault setting instructions, see
NetApp Link Key Manager (LKM/SSKM)"
-
For ESKM/SKM key vault setting instructions, see
Enterprise Secure Key Manager (ESKM/SKM)"
-
For TEKA key vault setting instructions, see
e_Security keyAuthority (TEKA)"
-
For TKLM key vault setting instructions, see
Key Lifetime Manager (TKLM)"
-
For KMIP key vault setting instructions, see
Management Interoperability Protocol"
shows the key vault selection dialog box for DPM.
Select Key Vault dialog box for DPM
Creating a new encryption group
"Configuring key vault settings for RSA Data
on page 769.
"Configuring key vault settings for
on page 774.
"Configuring key vault settings for HP
on page 780.
"Configuring key vault settings for Thales
on page 784.
"Configuring key vault settings for IBM Tivoli
on page 789.
"Configuring key vault settings for Key
on page 794.
"Creating a new encryption group"
20
769