Editing The Emc Call Home Center - Brocade Communications Systems WFT-2D User Manual

9
Editing a Call Home center

Editing the EMC Call Home center

To edit an EMC Call Home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
2. Select the EMC Call Home center you want to edit in the Call Home Centers list.
3. Click Edit Centers (beneath the Call Home Centers list).
4. Make sure the EMC Call Home center type displays in the Call Home Centers list.
5. Select the Enable check box to enable this Call Home center.
6. Set the time interval at which to check the Call Home center by selecting the Set heartbeat
7.
8. Enter the phone number or extension of the local server in the Local Server - Modem # field.
9. Enter the identification number of the local server in the Local Server - Cabinet Serial # field.
10. Enter the site name for the local server in the Local Server - Site Name field.
11. Click Send Test to test the Connect EMC application.
12. Click OK to close the "Test Event Sent" message.
400
The Call Home dialog box displays.
The Configure Call Home Center dialog box displays
FIGURE 172
Configure Call Home Center dialog box (EMC option)
If the Call Home center type is incorrect, select the correct type from the list.
interval at ___ days (1-28) check box and entering the interval in the field.
Enter the path to the ConnectEMC application in the ConnectEMC field or browse to the
ConnectEMC application location.
The selected Call Home center must be enabled to test the ConnectEMC application.
A faked event is generated and sent to the selected Call Home center. You must contact the
Call Home center to verify that the event was received and in the correct format.
(Figure 172).
Brocade Network Advisor SAN User Manual
53-1003154-01