Fcoe Licensing; Saving Running Configurations; Copying Switch Configurations To Selected Switches - Brocade Communications Systems WFT-2D User Manual

16

FCoE licensing

FCoE licensing
The FCoE license enables Fibre Channel over Ethernet (FCoE) functionality on the following
supported DCB switches:
•
•
•
•
•
Without the FCoE license, the DCB switches are pure Layer 2 Ethernet switches and do not allow
FCoE bridging capabilities.

Saving running configurations

The Save Running to Startup dialog box lists discovered DCB switches with Fabric OS version 6.3x
firmware or later. You can select available switches and move them to the Selected Switches list.
Upon startup, the DCB switch configuration is copied to the selected switches.
NOTE
The Save Running to Startup dialog box launches if there is at least one DCB switch discovered. If
no DCB switches exist, a warning message displays.

Copying switch configurations to selected switches

1. To access the Save Running to Startup dialog box, select Configure > Configuration > Save
604
Network OS 10 GbE 24-port 8 GbE 8 FC port switch
Network OS VDX 6710, 6720, and 6730 switches
Network OS VDX 6740 and 6740T switches
Network OS VDX 8770-series switches
Network OS VDX 2730 10 GbE connection blade for the Fujitsu PRIMERGY BX900 and BX400
Blade Servers
Running to Startup.
The Save Running to Startup dialog box displays, as shown in
FIGURE 230
Save Running to Startup dialog box
Figure 230.
Brocade Network Advisor SAN User Manual
53-1003154-01