Brocade Communications Systems WFT-2D User Manual page 1006

22
Connecting cascaded FICON fabrics over FCIP
7.
8. Follow these guidelines when configuring circuits through the Add FCIP Circuit dialog box.
9. After you complete tunnel and circuit configuration between the fabrics, merge the fabrics
10. Consider the following when merging fabrics:
11. After fabrics are successfully merged, configure FICON Emulation features as required. Refer
12. Rezone the fabric as zoning was removed from the secondary fabric that you merged.
13. Configure traffic isolation (TI) zoning. Refer to the information on TI zones under
14. Clear error counters, which are common during switch configuration, by right-clicking the
954
•
Set only one type of acceleration feature per tunnel. Tape and XRC Emulation must not be
enabled on the same tunnel.
•
Except for tape and XRC emulation, it is not necessary to isolate traffic for emulation
features.
Configure circuits for tunnels using steps under and
•
Start by configuring circuit 0, and then add additional circuits if desired.
•
Be sure to select Verify IP Connectivity to test the connection between both switches. IP
connectivity is tested with the ping utility.
•
Make changes to IP settings by selecting Advanced Settings to display the FCIP Circuit
Advanced Settings dialog box. Make changes to this dialog box only under direction of
network administrators.
using the Cascade FICON Fabrics Merge wizard by following procedures under"Cascaded
FICON fabric merge" Chapter 25, "FICON
•
When merging fabrics, the primary fabric is the production fabric where disruption should
not occur. The merge process will not make any disruptive configuration changes on the
primary fabric. The secondary fabric is merged into the primary fabric.
•
Any CHPIDs with local connections in the secondary fabric should be configured offline.
•
The merged fabric will retain zone configurations from the primary fabric, so any zone
configurations involving ports on the secondary fabric must be redone after fabric merge.
•
If the configuration wizard was used previously, the fabrics they will not merge. This is
because the wizard sets the fabric security policies based on the fabric that is present at
the time. Typically, this happens when a DR site is tested and validated before merging the
fabrics. If this occurs you will get fabric security violation errors and the ports will
automatically disable. To resolve this, keep working through the wizard regardless of any
error messages. Do not bother to set any long distance modes. Re-enable the ports that
were disabled due to a security violation as illustrated, then repeat the process.
•
There are no long-distance parameters to configure for IP links. Except for CWDM, most
DWDM equipment provides the required buffer credits Typically, it is only necessary to set
long distance mode when there are direct fibre runs.
•
For other considerations and a description of the merge process, refer decussated FICON
fabric merge" Chapter 25, "FICON
to step 6.
configuration" on page 952 and the "Traffic Isolation zones" section of
switch in the Connectivity Map or Product List and selecting Performance > Clear Counters.
When merging fabrics in production environments, always check with the system administrator
before clearing error counters.
"Adding an FCIP circuit"
Environments".
Environments".
Brocade Network Advisor SAN User Manual
on page 962
"Planning the
Chapter 21, "Zoning".
53-1003154-01