Oil Cooler Installation - Toyota 1HD-FT Repair Manual

EG-206
ENGINE - LUBRICATION SYSTEM
2.
INSPECT CHECK VALVE
Push the valve with a wooden stick to check if it is
stuck.
;~~~~~Zh
If stuck. replace the check valve.
3. INSPECT OIL COOLER
Check the oil cooler for damage or clogging.
If necessary. replace the oil cooler.
--
OIL COOLER INSTALLATION
,. INSTALL OIL COOLER TO OIL COOLER COVER
Install 2 new gaskets and the oil cooler to the oil
cooler cover with the 4 nuts.
Torque: 15.7 N·m (160 kgf·cm.12 ft·lbf)
2. INSTALL OIL COOLER AND COVER ASSEMBLY
Install a new gasket. the oil cooler and cover assembly
with the 13 bolts and 2 nuts. Uniformly tighten the
bolts and nuts in several passes.
Torque: 19.8 N·m (200 kgf·cm. 14 ft·lbf)
HINT: Each bolt length is indicated in the illustration.
Bolt length:
A 20 mm (0.78 in.)
B 40 mm (1.57 in.)
3. INSTALL OIL DIPSTICK GUIDE AND OiL DIPSTICK
(a) Install a new 0 - ring to the dipstick guide.
(b)
Apply soapy water to the a-ring.
(c) Push in the dipstick guide end into the guide hole of
the cylinder block.
(d) Install the oil dipstick guide with the bolt.
Torque: 19.6 N·m (200 kgf·cm. 14 ft·lbf)
(e) Install the dipstick.