Toyota 1HD-FT Repair Manual page 50

ENGINE - ENGINE MECHANICAL
EG-37
A
(e) Install the timing gear cover. clamp and bracket with
the 14 bolts.
Torque: 19.6 N·m (200 kgf·cm. 14 ft·lbtl
HINT: Each bolt length is indicated in the illustration.
Bolt length:
A 25
mm
(0.98
in.)
8
50 mm
(1.97
in.)
Bracket
Mm
EG
New
O-Ring
"""
7. INSTALL CRANKSHAFT PULLEY
(a) Install a new
a-ring
to the crankshaft pulley groove.
(b) Align the set key on the crankshaft with the key
groove of the crankshaft pulley.
(c) Using SST and a hammer. tap in the crankshaft pulley.
SST 09214-60010
(d) Temporarily install the plate washer and pulley nut.
NOTICE: Do not turn the crankshaft pulley. The valve
h••d, will hit againlt the pitton top.
B. INSTALL VACUUM PUMP
(a) Install a new O-ring to the vacuum pump.
(b) Install the vacuum pump with the 2 nuts.
Torque: 39 N·m (400 kgf·cm. 29 ft·lbf)
9. INSTALL OIL PIPE
Install the oil pipe with the bolt. 2 union bolts and 4
new gaskets.
Torque:
Bolt
1S.6
N·m (200 ksf·cm.
14
ft.lbf)
Union bolt
18 N·m (185 kgf·cm. 13 ft·lbf)
10. INSTALL CAMSHAFT OIL SEAL RETAINER
(See Itep 6 in cylinder head inltallation)
11. INSTALL TIMING PULLEYS AND TIMING BELT
(See steps 1 to 10 in timing belt installation)
12. TIGHTEN CRANKSHAFT PULLEY BOLT
Using SST. tighten the pulley nut.
SST 09213-58012 (90201 -08131. 91111- 508451.
09330-00021
Torque: 430 N·m (4.400 kgf·cm. 317 ft·lbfj
13. INSTALL WATER PUMP PULLEY. FAN. FLUIO
COUPLING AND ORIVE BELTS
(See Itep 7 in water pump installation in Cooling
SYltem)