Injection Pump Assembly - Toyota 1HD-FT Repair Manual

EG-140
ENGINE - FUEL SYSTEM
d11 '--' -111
~b
w~.o
Q
er
, 0 0
If -I
II ' -I
...
,
)
-~,)
o@
~/
.
~
~~~
""'''
(b) Apply MP grease to the tip of a new oil seal.
(e) Using a 22 mm socket wrench. tap in the oil seal until
its surface is flush with the pump housing.
--.
INJECTION PUMP ASSEMBLY
1. INSTALL FUEL INLET HOLLOW SCREW
Install a new gasket and the hollow screw.
Torque: 37 N·m (375 kgf·cm. 27 ft.lbf)
2. INSTALL REGULATOR VALVE
(a) Install 2 new 0 - rings to the regulator valve.
(b) Using SST. install the regulator valve.
SST
09260-54012 (09262-540201
Torque: 8.8 N·m (90 kgf·cm. 78 in.·lb')
3. INSTALL FUEL FEED PUMP
(a) Install the liner. rotor and 4 blades.
(b) Check that the liner and blades are facing in the
correct direction. as shown.
(c) Check that the blades move smoothly.
(d) Align the fuel outlet holes of the cover and liner.
(e) Install the pump cover with the 2 screws.
Torque: 3.0 N·m (31 kgf·em, 27 in.·lbf)
(f)
Check that the rotor moves smoothly.