Toyota 1HD-FT Repair Manual page 98

ENGINE - ENGINE MECHANICAL
EG-85
. .
. .
-
-
0:
b
0
0 0 0 0 0
.
.
. .
Seal Width 4 - 5 mm
"-"
"""
3. PLACE CRANKSHAFT ON CYLINDER BLOCK
4. INSTALL THRUST WASHERS
(a) Push the crankshaft toward the front (rear) side.
(b) Install the 4 thrust washers to the No.4 journal posi-
tion of the cylinder block with the oil grooves facing
outward.
5. INSTALL MAIN BEARING CAPS
A. Place main bearing cap on cylinder block
(a) Remove any old packing (FIPG) material and be care-
ful not to drop any oil the contact surfaces of the main
bearing cap and cylinder block.
• Thoroughly clean all components to remove all
the loose material.
• Using a non-residue solvent. clean both sealing
surfaces.
(b) Apply seal packing to the cylinder block as shown in
the illustration.
$eal packing:
Part No. 08826-00080 or equivalent
• Install a nozzle that has been cut to a 4 - 5 mm
(0.16 - 0.20
in.) opening .
• Parts must be assembled within 5 minutes of
application. Otherwise the material must be re-
moved and reapplied.
• Immediately remove nozzle from the tube and
reinstall cap.
(e) Install a new cylinder block hole gasket.
(d) Place the main bearing cap on the cylinder block.
B. Install main bearing cap bolts (12 pointed head)
HINT:
• The main bearing cap bolts are tightened in 2
progressive steps (steps (b) and (d)).
• If
anyone of
the main bearing cap bolts is broken
or deformed. replace it.
EG