Toyota 1HD-FT Repair Manual page 206

EG·' 94
ENGINE - LUBRICATION SYSTEM
'EG
.;':.;l;>,\\-SST
•
Car. should be t.ken. ther.for., when changing
angina oil to minimize the frequency and length of
tim. your akin i. expos.d to us.d engine oil. Protec-
tiv. clothing and glov•• that cannot b. penetrated
by oilahould b. worn. Th. akin should b. thoroughly
w.. hed with soap end water. or us. water-less
hand cle.ner. to remova any us.d engine oil. Do not
u•• g •• oline. thinner•. or solvents.
• In order to pr••• rve the environment. used oil end
used oil filter. must b. dispos.d of only at d.,igna-
ted disposal .it••.
,. DRAIN ENGINE OIL
(a) Remove the oil filler cap.
(b) Remove the oil drain plug, and drain the oil into a
container.
2. REPLACE OIL FILTER
(a) Using SST. remove the oil filter.
SST 0922B-l 0002
(b) Clean the oil filter contact surface on the oil filter
mounting,
(c) Lubricate the filter rubber gasket with clean engine
oil.
(d) Tighten the oil filter by hand until the rubber gasket
contacts the seat of the filter mounting.
(e) Using SST. give it an additional 3/4 turn to seat the
filter.
SST 0922B-l 0002
3. REFILL WITH ENGINE OIL
(a) Clean the drain plug, and install a new gasket and it.
Torqu.: 34.3 N·m (350 kgf·cm. 25 ft·lbf)
(b) Fill with new engine oil.
Capacity:
Drain and r.fill
wi
Oil filt.r cheng.
9.7 lit.r. (10.3 US qu, 8.Slmp. qts)
w/o
Oil
filter chang.
8.4 liter. (8.9 US qt•. 7.4 Imp. qt.)
Dry fill
10.0 lite,. (10.6 US qts, 8.8 Imp. qts)
(c) Reinstall the oil filler cap.
4. START ENGINE AND CHECK FOR OIL LEAKS
5. RECHECK ENGINE OIL LEVEL