Table of Contents
Advertisement
Shim thiekn...
EG-144
A
ENGINE - FUEL SYSTEM
Plunge' spring shim .election chert:
M...ur.clel'lr.ne.
MOl"
than
6.5 (0.256)
6.2 - 6.4 (0.248 - 0.252)
6.0 - 8.1 (0.236 - 0.2(0)
5.8 - 5.9 (0.228 - 0.232)
5.5 - 5.7 (O.217 - 0.224)
5.2 - 5.4 (0.205 - 0.213)
L... thin 5.0 (0.1971
mm (in.)
0.5 (O.020)
0.8 (O.031)
1.0 (0.039)
1.2 (0.047)
1.5(0.059)
1.8(0.071)
2.0 (0.079)
HINT:
•
For a measurement between listed sizes. use the
next larger size. For example.
if
thickness is 1.1
mm
(0.043
in.) by calculation. use a 1.2 mm
(0.047
in.)
shim.
•
Select 2 shims which have the same thickness.
10.
INSTALL COUPLING
Install the coupling.
",.ro
11. INSTALL FACE CAMPLATE
(a)
Face the drive shaft with the key groove facing
upward.
(b)
Install the camplate with the camplate pin facing the
governor cover side.
12.
INSTALL GOVERNOR LINK
(a)
Using SST, install the governor link with 2 new gas·
kets and the 2 support bolts.
Torqu.:
14 N·m {1.0 kgf·cm, 10 ft·lbfl
SST
09260-54012 (09269-540401
(b) Check that the governor link moves smoothly.
13. INSTALL PUMP PLUNGER
(a)
Place the previously used plunger adjusting shim on
the center of the camplate.
NOTICE:
Do not
.pply gr••••
to
the .him.
Hide quick links:
Advertisement
Table of Contents
