Toyota 1HD-FT Repair Manual page 158

ENGINE - FUEL SYSTEM
EG-145
(3)
(b) Install these parts to the pump plunger:
(1) Lower plunger plate
(2) Upper plunger plate
(3) Lower spring seat
(4) Spill ring
HINT: Face the spill ring with the hole facing the lower
spring seat.
(e) Align the pin groove of the plunger with the pin of the
face camplate.
(d) Align the ball pin of the governor link with the pin hole
of the spill ring.
(e) Using SST. install the pump plunger and 2 plunger
springs.
SST 09260-54012 (09269-540301
14. INSTALL DISTRIBUTIVE HEAD
(a)
Apply
grease to these parts and install them to the
distributive head:
(1)
2 plunger spring guides
(2) 2
new
selected plunger spring shims
(3) 2 upper spring seats
(4) 2 lever support springs
(5) New 0 - ring
fU0210 FU021l
mlD7
(b) Install the distributive head.
NOTICE: Be careful not to damage the pump plunger.
5mm
Hexagon
Wrench
(el Using a 5 mm hexagon wrench. install the 4 bolts and
wire clip.
Torque: 12 N·m (120 kgf·cm. 9 ft.lbf)
HINT: Use the bolt which is 45 mm (1.77 in.) in length.