Toyota 1HD-FT Repair Manual page 258

CHARGING SYSTEM - ALTERNATOR
CH-13
5. INSTALL RECTIFIER HOLDER
(a) Install the 4 rubber insulators on the lead wires.
""."
(b) Install the rectifier holder while pushing it with the 4 CH
screws.
Torque: 2.9 N·m (30 kgf·em. 28 In..lbf)
Upward
t
CB
6. INSTALL IC REGULATOR AND BRUSH HOLDER
(a) Place the seal plate on the rectifier end frame.
(b) Place the
Ie
regulator and brush holder on the rectifier
end frame.
NOTICE:
B.
c.r.ful of the hold., intt.lI.tion direction.
(e) Install the 5 screws.
(d) Place the brush holder cover on the brush holder.
7. INSTALL REAR END COVER
la) Install the end cover and plate terminal with the 3 nuts
and bolt.
Torque:
Bolt: 3.8 N·m (38 kgf·cm. 34 In.-Ibf)
Nut 80 A: ....4 N·m (45 kgf·em, 39 in..lbf)
100 A: 4.5 N·m (48 kgt·em, 40 in.-Ibf)
(b) Install the terminal insulator with the nut.
Torque:
80 A: 4.1 N·m (41.5 kgf·cm. 38 in..lbf)
100 A: 8.5 N·m (88 kgf·cm. 58 in..lbf)