Toyota 1HD-FT Repair Manual page 165

EG
EG-152
5mm
Hexagon
Wrench
+
ENGINE - FUEL SYSTEM
(f)
Using a 5 mm hexagon wrench. install the diaphragm
cover with the 4 bolts.
Torque: 7.35 N·m (75 kgf·cm. 86 in..lbf)
"""
C. In.tell lever control .pring
Install the lever control spring with a new gasket and
the bolt.
Torque: 11.3 N·m (115 kgf·cm. 8 ft·lbt)
26. INSTALL INJECTION PUMP STAY
Torque: 8.35 N·m (85 kgf·cm. 74 in.·lbf)
27. INSTALL FUEL CUT SOLENOID
(a) Install a new O-ring on the fuel cut solenoid.
(b) Install the wave washer. strainer. valve. spring and
fuel cut solenoid.
Torque: 22 N·m (225 kgf·cm. 16 ft·lbf)
Ie) Install the lead wire to the fuel cut solenoid with the
nut.
Torque: 1.7 N·m (17 kgf·cm. 15 inAbf)
(d) Install the dust cover to the fuel cut solenoid.
(e) Install the wire harness to the wire clip.
(f)
Install the lead wire connector to the bracket.
28. INSTALL CAP
Install a new gasket and the cap.
Torqu.: 11 N·m (115 kgf·cm, 8 ft·lbf)
29. INSTALL NO.1 SICS LEVER
(a)
Align the lines of the levers.
(b) Install the nut.
Torqu.: 8.9 N·m (70 kgf·cm. 81
in.·lbf)