ENGINE - COOLING SYSTEM
HINT: The thermostat is numbered with the valve
- - -
Immerse the thermostat in water and gradually heat
Check the valve opening temperature.
V.lve opening tempereture:
7. - 7S"C 1165 - In"F)
If the valve opening temperature is not as specified.
replace the thermostat.
Check the valve lift.
(0.39 In.) or mor••
If the valve lift is not as specified. replace the thermo-
Check that the valve spring is tight when the thermo-
stat is fully closed.
closed. replace the thermostat.
PLACE THERMOSTAT IN CYLINDER SLOCK
Install a new gasket to the thermostat.
Ins1all the thermostat with the jiggle valve upward.
INSTALL WATER INLET
Temporarily install the water inlet with the 3 bolts.
Alternately tighten the
bolts in several passes.
Torque: t9.8 N·m (200 kgf·cm. 14 ft·lbfl
FILL WITH ENGINE COOLANT
START ENGINE. AND CHECK FOR COOLANT