Toyota 1HD-FT Repair Manual page 257

CH-12
29 mm
SOCkel-7::='f~-:'::;;!1:
Wrench
CHARGING SYSTEM - ALTERNATOR
3. INSTALL RECTIFIER END FRAME
(a) Place the alternator washer on the rotor.
(b) Using a 29 mm socket wrench and press, slowly press
in the rectifier end frame.
(c) Install the 4 nuts.
Torque: 4.5 N·m (46 kgf·em, 40 in.·lbf)
,.,...
4.
INSTALL PULLEY
(aJ Install the pulley to the rotor shaft by tightening the
pulley nut by hand.
(b)
Hold SST (A) with a torque wrench. and tighten SST
(8) clockwise to the specified torque.
SST 09820-6301 0
Torque: 39 N·m (400 kgf·cm, 29 ft·Jbf)
(e) Check that SST (A) is secured to the pulley shaft.
...."
(d) As shown in the illustration. mount SST
(C)
in a vise.
and install the alternator to SST
(C).
(e)
To torque the pulley nut. turn SST (A) in the direction
shown in the illustration.
Torque: 110 N·m (1.125 kgf·cm. 81 ft·lbf)
(n
Remove the alternator from SST
(C).
(9) Turn SST (B) and remove SST (A and BI.
1"08~.1PW2 ...
"""