Timing Gears Installation - Toyota 1HD-FT Repair Manual

ENGINE - ENGINE MECHANICAL
EG·35
(b) Using SST and a hammer. tap in a new oil seal until its
surface is flush with the timing gear cover edge.
SST 09214-76011
(c) Apply MP grease to the oil seal lip.
"""
EG
B. If timing gear cover is installed to the cylinder block:
(a) Using a knife. cut off the oil seal lip.
(b) Using a screwdriver. pry out the oil seal.
NOTICE: B. careful not to damage the injection pump
drive g8.r. Tepa the screwdriver tip.
(c) Apply MP grease to the oil seal lip.
(d) Using SST and a hammer. tap in a new oil seal until its
surface is flush with the timing gear cover edge.
SST 09214-76011
"""
__-0'
TIMING GEARS INSTALLATION
1. INSTALL CRANKSHAFT TIMING GEAR
(a) Put the timing gear with the timing mark facing for-
ward.
(bl Align the set key on the crankshaft with the key
groove of the timing gear.
(e) Using SST and a hammer. tap in the timing gear.
SST 09223-00010
2. INSTALL INJECTION PUMP DRIVE GEAR
(a) Align the set key on the drive shaft with the key
groove of the drive gear. and install the drive gear.
(b) Install a new 0 - ring to the drive gear groove.
(e) Install the gear nut.
(d) Using SST. tighten the gear nut.
SST 09960-10010 (09962-01000.09963-00700)
Torque: 98 N·m (1.000 kgf·cm. 72 ft·lbf)