Table of Contents
Advertisement
EG-130
ENGINE - FUEL SYSTEM
11. REMOVE FUEL CUT SOLENOID
(a)
Disconnect the lead wire connector from the bracket.
(b) Disconnect the wire harness from the wire clamp.
(c)
Disconnect the dust cover from the fuel cut solenoid.
(d)
Remove the nut. lead wire and dust cover.
(a)
Remove the fuel cut solenoid. O-ring, spring, valve.
strainer and wave washer.
12. REMOVE PICKUP SENSOR
(a)
Remove the pickup sensor and O-ring.
(b)
Disconnect the sensor lead wires from the connector.
13. REMOVE ADJUSTING LEVER
(a)
Place the match marks on adjusting lever and shaft.
(b)
Remove the nut, adjusting lever and return spring.
14. REMOVE GOVERNOR COVER
(a)
Remove the idle speed adjusting screw.
(b)
Using a 5 mm hexagon wrench. remove the 4 bolts.
5mm
Hexagon
Wrench
Hide quick links:
Advertisement
Table of Contents
