Toyota 1HD-FT Repair Manual page 166

ENGINE - FUEL SYSTEM
EG-153
Melal Plale •
~h":::::J
-'
5 mm Hexagon,
~':.-"~./\<:'I....\
Wrench
5 mm Hexagon Wrench
30. INSTALL SICS ACTUATOR
(a) Using a 5 mm hexagon wrench. install the SICS ac·
tuator bracket with the 3 bolts.
Torque: 8.3 N·m (95 kgt·em. 82 in..lbf)
(b) Install the maximum speed adjusting screw.
(c) Install the lock plate to the maximum speed adjusting
screw.
(d) Install the SICS actuator with a nut.
Torque: 9.35 N·m (95 kgf·em, 83 in.·lb')
NOTICE: In.t.1I 2 actuator adju.ting wa,h.,. on the .id.
with the nut.
(e) Install the clip.
(f) Install the SICS adjusting screw.
Torque: 6.9 N·m (70 kgt-em. 61 In..lbt)
(g)
Connect the wire harness.
31. INSTALL THERMO WAX
(a) Using a screwdriver. turn the cold starting lever coun-
terclockwise approx. 20
0
•
(b) Put a metal plate (thickness of 5.0 - 8.0 mm (0.20 -
0.31 in.)) between the cold starting lever and thermo
wax plunger.
(c) Install a new O-ring to the pump body.
(d) Using a 5 mm hexagon wrench, temporality install the
thermo wax with the 2 bolts.
(e) Using a screwdriver, turn the cold starting lever coun·
terclockwise.
(f) Using a 5 mm hexagon wrench, install the bolt (B).and
removal the bolt (A).
Torque: 8.35 N·m (85 kgf·cm. 74 In..lbf)
(g) Using a 5 mm hexagon wrench. tighten the bolt.
Torque: 8.35 N·m (85 kgf·cm, 74 in..lbf)
32. INSTALL IDLE-UP LEVER
Using a 5 mm hexagon wrench. install the idle-up
lever with the 3 bolts.
Torque:
Short bolt: 8.35 N·m (85 kgf·cm. 74 in.·lbf)
Long bolt: 11.75 N·m (120 kgf·cm. 9 ft.lbf)
33. REMOVE INJECTION PUMP FROM SST (STANO)
SST 09241-76022. 09245-54010
EG