Toyota 1HD-FT Repair Manual page 163

EG·150
ENGINE - FUEL SYSTEM
EG
r--
(i)
After completing the pre
stroke adjustment. check
that dimension B is within the specifications.
Dimenlion B: 3.4 - 3.8 mm (0.134 - 0.'42 in.)
riltWf
If dimension B is not within the specification. replace
the distributor head.
If-- t~
~
..
~
(P)J)
mo,
C::=:-I~c;;;~;(Shjm
24. INSTALL DISTRIBUTIVE HEAD PLUG
(a) Install a new O-ring to the head plug.
(b) Using SST. install the head plug.
SST
09260-54012 (09262-540101
Torque: 88 N·m (900 kgf·cm. 86 ft·lbf)
25. ASSEMBLE BOOST COMPENSATOR
A. Inltell guide bushing
Install and adjust the guide bushing to the dimension
"A" as shown in the illustration.
Dimension ".":
Euro~ 17.3 - 17.4 mm (0.881 - 0.885 in.)
Austr.li. 18.9 - 19.0 mm (0.744 - 0.748 In.)
B. Inltell boost compen•• tor diaphragm
(a) Adjust boost compensator shim.
• Place the shim on the guide bushing.
• Using vernier calipers, measure the dimension -B-
as shown in the illustration.
Dim.nsion ·8·:
Euro~
3.8 - 3.8 mm (0.142 - 0.150 In.)
Austr.lI. 3.1 - 3.3 mm (0.122 - 0.130 in.)
If the dimension is not within specification. select and
install the correct shim.
HINT: Shim are available in sized in increments 0.2
mm (0.008 in.), from 1.1 mm (0.043 in.) to 3.3 mm
(0.130
in.).