Download  Print this page

Piston And Connecting Rod Disassembly - Toyota 1HD-FT Repair Manual

Hide thumbs

Advertisement

Table of Contents
""'''
1.
CHECK FIT BETWEEN PISTON AND PISTON PIN
Try to move the piston back and forth on the piston
pin.
If
any movement is
felt. replace the piston and pin as
a set.
--.
PISTON AND CONNECTING ROD
DISASSEMBLY
ENGINE - ENGINE MECHANICAL
EG-74
2_
REMOVE PISTON RINGS
(a)
Using a piston ring expander. remove the No.1. No.2
and oil rings.
(b)
Remove the coil by hand.
HINT: Arrange the rings in correct order only.
3.
DISCONNECT CONNECTING ROD FROM PISTON
(a)
Using a small screwdriver. pry off the snap ring from
the piston.
(b)
Gradually heat the piston to approx.
SDoe
(176°F).
(c)
Using a plastic-faced hammer and brass bar. lightly
tap out the piston pin and remove the connecting rod.
HINT:
The piston and pin are a matched set.
Arrange the pistons. pins. rings. connecting rods
and bearings in corract order.

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments:
  • Dibakar Kundu Aug 13, 2019 04:39:
    much helf full to us,we hope will get this type of support in future.