'EG
EG·136
ENGINE - FUEL SYSTEM
(c)
Push the drive shaft. and remove the roller
ring.
4
rollers and shims assembly.
NOTICE,
•
8. car.ful not to drop the roller•.
•
00
not .It.r
the position or ••••mbly of the rolle,..
(d)
Using vernier calipers. measure the protrusion of the
coupling spring.
Protrusion:
1.0 - 1.4
mm
(0.03937 - 0.05512
in.)
If the protrusion is not as specified. replace the cou-
pling spring.
NOTICE: Do not remove the coupling spring unlit,. neees-
..,y. If you remove the coupling
spring,
replace
it
with.
new one.
(e)
Remove the drive shaft. governor drive gear. 2 joint
rubbers assembly, set key and drive shaft washer.
Joint Rubber
Drive Shaft Assemblv
(1)
Remove the drive gear and 2 joint rubbers from the
drive shaft assembly.
5mm
Hexagon
Wrench
26. REMOVE TIMER
(a)
Using a 5 mm hexagon wrench. remove the 4 bolts.