DGS-3620 m/ mSW Rls. 1.02.000
5-2 shutdown
shutdown
no shutdown
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface loopback 1
Switch(config-if)# shutdown
CLI Reference Guide
Use the command to disable an interface. Use the no command to enable an interface.
None.
Default the interface is enabled.
Interface configuration mode.
This command is used to disable or enable an interface. You can verify the settings by
entering the show interface loopback command.
To shutdown the loopback interface 1.
shutdown
225