Ip Ospf Priority - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

11-18 ip ospf priority

ip ospf priority PRIORITY
no ip ospf priority
Syntax Description
PRIORITY
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip ospf priority 50
CLI Reference Guide
Use this command to configure the router priority that is used to determine the
designated router for the network. Use the no command to restore it to the
default value.
Specifies the priority of the router on the interface.
The value range is 0 to 255.
The default priority is 1.
Interface configuration mode
The OSPF router will determine a designated router for the multi-access network.This
command sets the priority used to determine the OSPF Designated Router (DR) for a
network. If two routers attempt to become the DR, the router with the higher router
priority will be elected to the DR. If the routers have the same priority, the router with
the higher router ID takes precedence.
Only routers with nonzero router priority values are eligible to become the designated
or backup designated router.
Users can verify the settings by entering the show ip ospf interface command.
To set the priority of the System interface (vlan 1) to 50.
ip ospf priority
342