D-Link xStack DGS-3620 Series Reference Manual page 8

DGS-3620 m/ mSW Rls. 1.02.000
User Access Verification
Username: power-user
Password:
Copyright (c) 2010 D-Link Corporation. All rights reserved.
DGS-3620:oper#
Privileged EXEC Mode at Administrator Level
This command mode has a privilege level of 15. Users logged in with this command mode can monitor all
system information and change any system configuration settings mentioned in this Configuration Guide.
The method to enter privileged EXEC mode at administrator level is to login to the Switch with a user
account that has a privilege level of 15.
Global Configuration Mode
The primary purpose of global configuration mode is to apply global settings on the entire Switch. Global
configuration mode can be accessed at both power user and administrator level. However, security
related settings are not accessible at power user level. In addition to applying global settings on the entire
Switch, the user can also access other sub-configuration modes.
In order to access global configuration mode, the user must be logged in as an administrator or power
user and use the configure terminal command in privileged EXEC mode.
In the following example, the user is logged in as an Administrator in privileged EXEC mode and uses the
configure terminal command to access global configuration mode:
DGS-3620:15#configure terminal
DGS-3620:15(config)#
The exit command is used to exit global configuration mode and return to privileged EXEC mode.
The procedures to enter the different sub-configuration modes can be found in the related chapters in this
Configuration Guide. The command modes are used to configure the individual functions.
CLI Reference Guide
DGS-3620 Chassis-based High-Speed Switch
Command Line Interface
Firmware: 1.00.029
vii