Address-Family Ipv4 Vrf (Rip) - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

13-17 address-family ipv4 vrf (RIP)

address-family ipv4 vrf VRF-NAME
no address-family ipv4 vrf VRF-NAME
Syntax Description
vf VRF-NAME
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)# address-family ipv4 vrf VPN-A
Switch(config-router-af)#
CLI Reference Guide
Use this command to create an RIP VRF instance and enter RIP VRF address
family configuration mode. Use the no form of this command to destroy RIP VRF
instance.
Specifies the name of the VRF.
By default, no RIP VRF instance is created.
Router configuration mode.
This command is used to configure RIP routing instances that use IPv4 address
prefixes. After executing this command, the address family configuration mode
will be entered and a new RIP VRF routing instance will be created with this
command. If the no form of this command is executed, the related configurations
of the RIP VRF instance will be removed.
You can verify your settings by entering the show ip rip vrf command.
To create a new RIP instance in VRF VPN-A:
address-family ipv4 vrf (RIP)
437