Ip Vrf Forwarding - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

18-5 ip vrf forwarding

ip vrf forwarding VRF-NAME
no ip vrf forwarding VRF-NAME
Syntax Description
VRF-NAME
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 100
Switch(config-if)# ip vrf forwarding VPN-A
Switch(config-if)# end
Switch# config ipif vlan100 ipaddress 100.1.1.1/24 state enable
CLI Reference Guide
Use this command to associate one interface to a VRF instance. Use the no form
of this command to restore one interface to global routing instance.
Specifies the name of the VRF.
By default, no interface is associated to a VRF instance.
Interface configuration mode
This command is used to associate an interface to one VRF instance. After one
interface is associated to one VRF instance with this command, its IP address
will be restored to unspecified. User needs to set its IP address before use it.
By associating interfaces to different VRF, the interfaces in different VRF can be
configured with same IP address. The IP address space in one VRF is individual
and can overlap among different VRFs.
Use the command show ip vrf to check the settings.
To associate VLAN 100 interface to VRF VPN-A:
ip vrf forwarding
502