DGS-3620 m/ mSW Rls. 1.02.000
11-20 passive-interface
passive-interface {default | interface IPIF_NAME}
no passive-interface {default | interface IPIF_NAME}
Syntax Description
default
interface IPIF_NAME Specifies the interface with this name as passive interface.
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# passive-interface default
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# passive-interface interface System
CLI Reference Guide
Use the command to configure the specified OSPF interface as passive
interface. Use the no command to restore to the default value.
Specifies all the interfaces as passive interfaces.
By default no interface is configured as passive interface
Router configuration mode
If an interface is passive, the OSPF protocol packets are neither sent nor received
through the specified interface.
Users can verify the settings by entering the show ip ospf interface command.
To set all the interfaces to be passive:
To set System interface to be passive:
passive-interface
344