Ip Pim Dr-Priority - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

12-4 ip pim dr-priority

ip pim dr-priority PRIORITY
no ip pim dr-priority
Syntax Description
PRIORITY
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip pim dr-priority 100
Switch# configure terminal
Switch(config)# interface vlan 2
Switch(config-if)# no ip pim dr-priority
CLI Reference Guide
To configure the priority for which a switch is elected as the designated router
(DR), use the ip pim dr-priority command in interface configuration mode. To
return default, use the no form of this command.
The larger the value, the higher the priority is. The range is 0 to 4294967294.
1
Interface configuration mode
The switch with the biggest priority would be selected as DR on a LAN. If several
switches have the same
DR priority, the one with the highest IP address would be selected. If the DR priority
field is not set in PIM hello messages, the one with highest IP address is selected to
be DR.
To verify your configuration, use show ip pim sparse-mode interface detail.
Configure the priority of VLAN 1 to be 100.
Configure DR priority of VLAN 2 back to default.
ip pim dr-priority
391