D-Link xStack DGS-3620 Series Reference Manual page 174

DGS-3620 m/ mSW Rls. 1.02.000
Status codes
Origin codes
IP Address/
Netmask
Gateway
Metric
LocPrf
Weight
Path
CLI Reference Guide
Status of the table entry displayed at the beginning of each line. It can be one or more of
the following values:
s—The table entry is suppressed.
d—The table entry is damped.
h—The table entry is damped and has been withdrawn by the neighbor.
*—The table entry is valid.
>—The table entry is the best entry to use for that network.
i—The table entry was learned via an internal BGP (iBGP) session.
Origin of the table entry displayed at the end of each line. It can be one of the following
values:
i—Entry originated from an Interior Gateway Protocol (IGP) and was advertised with a
network router configuration command.
e—Entry originated from an Exterior Gateway Protocol (EGP).
?—Origin of the path is not clear. Usually, this is a router that is redistributed into BGP
from an IGP.
IP prefix with its mask length of the entry.
IP address of the next router that is used when forwarding a packet to the destination
network. An entry of 0.0.0.0 indicates that the router has some non-BGP routes to this
network..
If shown, this is the value of the inter-autonomous system metric. This field is frequently
not used.
Local preference value as set with the set local-preference route-map configuration
command. The default value is 100.
Weight of the route as set via autonomous system filters.
Autonomous system paths to the destination network.
show ip bgp filter-list
164