D-Link xStack DGS-3620 Series Reference Manual page 406

DGS-3620 m/ mSW Rls. 1.02.000
Example
Switch# configure terminal
Switch(config)# ip pim rp-candidate ipif1 priority 100 group-list crp-acl
Switch(config)# ip standard access-list crp-acl
Switch(config-standard-acl)#permit 234.0.0.0/12
Switch(config-standard-acl)#end
Switch# configure terminal
Switch(config)# no ip pim rp-candidate ipif1
Switch# configure terminal
Switch(config)# ip pim rp-candidate ipif1 wildcard-prefix-cnt 1
Switch# configure terminal
Switch(config)# no ip pim rp-candidate ipif1
CLI Reference Guide
interface as the candidate RP of a specific group, execute this command with ACL.
One interface can only configure one ACL.The number of ACL entry configured to
candidate RP is limited, and the total number of group range configured to candidate
RP is also limited. If any limitation exceeded, no more candidate RP can be created.
To verify your configuration, use show ip pim.
Configure candidate RP interface ipif1 with group range 234.0.0.0/12, and priority set
to 100.
Set CRP configuration back to default:
The following example configures the PIM wildcard prefix count to be 1:
Delete all CRP ACL list binding on the interface ipif1:
ip pim rp-candidate
396