D-Link xStack DGS-3620 Series Reference Manual page 491

DGS-3620 m/ mSW Rls. 1.02.000
17-5 mac-limit
mac-limit VALUE
Syntax Description
VALUE
Default
Command Mode
Usage Guideline
Example
switch(config-vpls)#mac-limit 4096
switch(config-vpls)#
CLI Reference Guide
Use the mac-limit command in VPLS configuration mode to set MAC address
learning limitation of a VPLS.
Specifies the limited number of learned MAC addresses in a VPLS.
The maximum value of limited number of learned MAC addresses is project
dependent setting. If a user specifies 0, there is no MAC address learning limitation in
this VPLS. For the DGS-3620, the maximum number is 32767.
0.
VPLS configuration mode.
This command is used to set MAC address learning limitation of a VPLS in VPLS
configuration mode. After a user set a non-zero MAC address learning limitation,
when the situation of over MAC address learning limitation happens, the packets with
unlearned source MAC address in the VPLS will be dropped.
The follow example shows how to set MAC address learning limitation of a VPLS to
4096.
mac-limit
481