Debug Ip Ospf Neighbor - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

11-32 debug ip ospf neighbor

debug ip ospf neighbor
no debug ip ospf neighbor
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch# debug ip ospf neighbor
Switch#
NBR 2.2.2.2 state change from LOADING to FULL tic 100
NBR 3.3.3.3 state change from FULL to DOWN tic 100
CLI Reference Guide
Use this command to turn on the OSPF neighbor state debug switch. Use the no
form of the command to turn off the OSPF neighbor state debug switch.
None.
By default the OSPF neighbor state debug switch is turned off.
Privileged mode.
Use this command to turn on or turn off the OSPF neighbor state debug switch.
When the neighbor state changes or some events happen to change the
neighbor state, debug information will print if the OSPF debug function is turned
on.
Use the command debug ip ospf to turn off the OSPF debug function.
The following example turns on OSPF neighbor state debug switch:
debug ip ospf neighbor
367