D-Link xStack DGS-3620 Series Reference Manual page 303

DGS-3620 m/ mSW Rls. 1.02.000
10-27 neighbor password
neighbor IP-ADDRESS password PASSWORD
no neighbor IP-ADDRESS password
Syntax Description
IP-ADDRESS
password
PASSWORD
Default
Command Mode
Usage Guideline
Example
Switch(config-mpls-router)#md5 authentication
Switch(config-mpls-router)#neighbor 10.90.90.12 password abcd
CLI Reference Guide
Use this command to configure a LDP peer password. Use the no form of this
command to restore the default value.
Specifies the peer IP address. The IP address shall be the peer's LSR ID.
Specifies the password. The maximum length of the password is 32 characters.
By default, a peer has no password.
MPLS router configuration mode.
Use this command to configure a LDP peer password. If the LDP MD5
authentication is enabled, the switch only establish session with these peers
whose password is configured at both local and remote. The password
configured on local must be same as remote peer.
Note: If the session of the peer is established, configuring the peer password will
lead to the session restart.
The user can verify their settings by entering the show mpls ldp neighbor
password command.
This example shows how to enable MD5 authentication and configure the peer
10.90.90.12 password to "abcd":
neighbor password
293