Mpls Ldp Remote-Peer - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

10-13 mpls ldp remote-peer

mpls ldp remote-peer IP-ADDRESS
no mpls ldp remote-peer IP-ADDRESS
Syntax Description
IP-ADDRESS
Default
Command Mode
Usage Guideline
Example
Switch(config)# mpls ldp remote-peer 110.10.10.1
Switch(config-mpls-remote-peer)#
CLI Reference Guide
Use the mpls ldp remote-peer command to create a LDP targeted peer. Use the
no form of this command to remove the previous configured LDP targeted peer.
Specifies the LSR ID of the targeted peer.
No remote peer.
Global configuration mode.
This command is used to create a targeted peer and enter MPLS remote peer
configuration mode. Targeted peer specifies a potential indirectly connected
neighbor. The extended discovery will be used to discover the targeted peer.
The user can verify their settings by entering the show mpls ldp remote-peer
command.
This example shows how to create a targeted peer 110.10.10.1:
mpls ldp remote-peer
279