D-Link xStack DGS-3620 Series Reference Manual page 292

DGS-3620 m/ mSW Rls. 1.02.000
10-16 transport-address
transport-address {interface | IP-ADDRESS }
no transport-address
Syntax Description
interface
IP-ADDRESS
Default
Command Mode
Usage Guideline
Example
Switch(config-mpls-router)# transport-address 192.168.0.1
CLI Reference Guide
Use this command to set the global transport address. Use the no form of this
command to restore the default value.
Use the IP address of the corresponding interface as the transmission address
for the session on each interface.
All sessions use this specified IP address as the transmission address uniformly.
Use the LSR ID as the transport-address.
MPLS router configuration mode.
This command is used to configure the LDP transport address. The transport
address is used to establish LDP TCP connection. By default, the LSR ID is used
as the transport address by all interfaces.
If you configure the transport address to "interface", the IP address of each
interface is used as the transport address.
If you configure the transport address to a specified IP address, this address is
used as transport address by all interfaces.
Note 1: If LDP is running, configuring transport address will lead to LDP sessions
restart.
Note 2: If LDP is running, link-down or deleting the interface which IP address is
used as transport address will lead to the LDP session down, so suggestion
using loopback interface as transport address.
The user can verify their settings by entering the show mpls ldp parameter
command.
This example shows how to configure the transport address to 192.168.0.1:
transport-address
282