D-Link xStack DGS-3620 Series Reference Manual page 514

DGS-3620 m/ mSW Rls. 1.02.000
18-7 rd
rd ROUTE-DISTINGUISHER
Syntax Description
ROUTE-
DISTINGUISHER
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# ip vrf VPN-A
Switch(config-vrf)# rd 100:1
Switch(config-vrf)#
CLI Reference Guide
Use this command to set the route distinguisher of one VRF.
Specifies VRF's route distinguisher, witch is used to prepend an 8-bytes value to
an IPv4 prefix to create a VPN-IPv4 prefix.
By default, no route distinguisher is set for one VRF.
VRF configuration mode.
This command is used to set VRF's route distinguisher to form unique VPN-IPv4
prefix. One VRF has only one route distinguisher and cannot be changed if it has
been set to one value.
Use the command show ip vrf to check the settings.
To create an VRF instance VPN-A and set its route distinguisher:
rd
504