Mpls Ldp Targeted-Hello-Accept - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

10-12 mpls ldp targeted-hello-accept

mpls ldp targeted-hello-accept
no mpls ldp targeted-hello-accept
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface vlan 10
Switch(config-if)# mpls ldp targeted-hello-accept
CLI Reference Guide
Use the targeted-hello-accept command to set the targeted hello message
acceptable on this interface. Use the no form of this command to deny the
targeted hello message acceptable.
None.
Acceptable.
Interface configuration mode.
This command only can be applied on a Layer 3 VLAN interface.
If the targeted hello message is acceptable, the interface will responds to
received targeted hello messages. Otherwise, if the received targeted hello is not
coming from the local configured targeted peer, the targeted hello message will
be ignored.
The user can verify their settings by entering the show mpls ldp interface
command.
This example shows how to configure the VLAN 10 interface to accept the
targeted hello message
:
mpls ldp targeted-hello-accept
278