D-Link xStack DGS-3620 Series Reference Manual page 154

DGS-3620 m/ mSW Rls. 1.02.000
Origin codes Origin of the table entry displayed at the end of each line. It can be
one of the following values:
i—Entry originated from an Interior Gateway Protocol (IGP) and was
advertised with a network router configuration command.
e—Entry originated from an Exterior Gateway Protocol (EGP).
?—Origin of the path is not clear. Usually, this is a router that is
redistributed into BGP from an IGP.
IP Address/ IP prefix with its mask length of the entry.
Netmask
Gateway IP address of the next router that is used when forwarding a packet to
the destination network. An entry of 0.0.0.0 indicates that the router
has some non-BGP routes to this network.
Metric If shown, this is the value of the inter-autonomous system metric. This
field is frequently not used.
LocPrf Local preference value as set with the set local-preference route-map
configuration command. The default value is 100.
Weight Weight of the route as set via autonomous system filters.
Route Specify the route distinguisher of the following routes.
Distinguisher
default for vrf Specify the VRF which The route distinguisher is default for.
VPN route(s) Specify that the following routes are learned from PEs.
Path Autonomous system paths to the destination network.
From Specify the origin of this prefix.
In label Specify the label which would be assigned to other routes that origin
from other PE.
Out label Specify the label which get form other PE neighbor.
Self Peer Specify that the route is originated from local.
no Specify this prefix does not have label of this direction.
CLI Reference Guide
show ip bgp rd
144