D-Link xStack DGS-3620 Series Reference Manual page 506

DGS-3620 m/ mSW Rls. 1.02.000
17-12 show mpls l2transport vc
show mpls l2transport vc [VC-ID] [detail]
Syntax Description
VC-ID
detail
Default
Command Mode
Usage Guideline
Example
switch#show mpls l2transport vc
VC ID Peer
---------- -------------- -------------------- ------
1 150.1.1.4
2 130.1.1.2
3 140.1.1.2
4 160.1.1.2
Total Entries: 4
switch#show mpls l2transport vc 5 detail
VC ID: 5, Peer IP Address: 120.1.1.2, Operate Status: Up
Local AC: vpls101, Status: Up
Remote AC Status: Up
MPLS VC Labels: Local 19, Remote 19
Outbound Tunnel label: 103
MTU: Local 1500, Remote 1500
Group ID: Local 0, Remote 0
Signaling Protocol: LDP
VC Statistics:
RX Bytes: 0, RX Packets: 0
TX Bytes: 0, TX Packets: 0
Total Entries: 1
CLI Reference Guide
Use the show mpls l2transport vc command in EXEC mode to show VC
information for VPWS and VPLS.
Optional, specifies the pseudowire id. The range is 1-4294967295.
Optional, specifies detail VC information.
N/A
EXEC mode
This command is used to show VC (detail) information for VPWS and VPLS.
To show all VC information including VPWS and VPLS.
Local AC
Eth1/VLAN2
Eth1/VLAN3
vpls100
vpls100
The following example shows how to show detail VC information for a VPLS.
Type Oper Status
-----------
Raw Up
Tagged Down
Tagged Up
Tagged Standby
show mpls l2transport vc
496