DGS-3620 m/ mSW Rls. 1.02.000
19-1 vrrp authentication
vrrp authentication STRING
no vrrp authentication
Syntax Description
STRING
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# vrrp authentication test
CLI Reference Guide
Use this command to enable VRRP authentication and set the password on an
interface. Use the no form of this command to remove the authentication.
Specifies the plaintext authentication password (8 characters).
By default no authentication is configured.
Interface configuration mode
This command is used to enable VRRP authentication on an interface. The
authentication is applied to all virtual routers on this interface.
The devices in the same VRRP group must have the same authentication password.
Use the command show vrrp to verify your settings.
Following example is to configure one interface's VRRP authentication:
vrrp authentication
509