Match Community - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

14-3 match community

match community COMMUNITY-LIST-NAME [exact]
no match community
Syntax Description
COMMUNITY-LIST-
NAME
exact
Default
Command Mode
Usage Guideline
Examples
Switch# configure terminal
Switch(config)# ip community-list standard DLINK-COMMUNITY permit 101:1
Switch(config)# route-map rmap1 permit 10
Switch(config-route-map)# match community DLINK-COMMUNITY exact
Switch(config-route-map)#
CLI Reference Guide
Use this command to add a match command to match a Border Gateway
Protocol (BGP) community list. Use the no form of this command to delete the
match command with BGP community list.
Specifies the name of BGP community list.
The length is up to 16 characters.
(Optional) Specifies to match BGP community list exactly.
None.
Route map configuration mode.
The BGP community list is created with the command ip community-list.
If exact is specified, the communities in the community list must be exactly same
as the communities of the route.
If exact is not specified, this command is matched as long as one community is
matched.
Only one community list is supported. If this command is executed with a
different community list, the old one will be overwritten.
You can verify your settings by entering the show route-map command.
To add a match command to match a BGP community list:
match community
443