Scene Setup; Setting Zone Levels, Fade Rates, And Shade Group Actions - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Scene Setup

Setting Zone Levels, Fade Rates, and Shade Group Actions

1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight "Scene setup" and press
Timeclock
the "OK" button to accept.
Scene setup
3. Use the Master buttons to highlight "Levels" to adjust lighting
and/or shade levels. Press the "OK" button to accept. Use the
Master buttons to highlight the scene number of your desired
Scene setup
scene. Press the "OK" button to accept.
Levels
4. Set each zone to the desired light level for this scene using
the zone raise/lower buttons. The info screen will display the
Labels
zone and percentage as you adjust it.
To set a zone as unaffected, lower the light levels all the way
Scene setup
to off, then hold the zone lower button for 3 seconds. The
screen will display "---" and the three middle LEDs for the
zone will be lit to indicate this zone is unaffected by the scene
Scene 1
(the zone will not change when this scene is initiated).
When all zones are at the desired level, press the "OK" button
to accept.
Scene 1
5. Use the Master buttons to set the fade time for this scene.
Set zones
Press the "OK" button to accept.
6. Note: This step is applicable only if you have shades on your
3 seconds
Scene 1
Set each shade group to the desired level for this scene.
Adjust fade
When all shade groups are at the desired level, press the
3 seconds
"OK" button to accept.
For shade programming, see the section on adjusting shade
settings.
Scene 1
7. The info screen will confirm that your scene has been saved.
Set shade
8. Exit programming mode.
Groups
Saved
®
system. If you do not have or do not wish to set shade
groups for this scene, press the "OK" button to skip this
step.
GRAFIK Eye QS Control Unit Installation and Operation Guide 20
®
Master
buttons
OK
"OK"
button
Timeclock
(back) button
Shade
button group
Zone raise
Zone lower