Brakes
Assemble the union tightening to the prescribed tor-
que.
23÷26 N•m
Torque pressure: 23 ÷ 26 N·m
NOTE
Substitute the gaskets with new ones.
Proceed with the filling and bleeding of the rear brake
system (see page 25).
Carry out the emptying of the brake system as pre-
Rear brake pump removal
viously described.
Loosen the nut (1) and remove the clip with the pump
control fork pin (2) by turning the pin and pulling it out
(see figure).
H
1
2
Disconnect the rear stop switch connector (1) once you
have removed the clamp (2).
2
1
- 28 -