Table of Contents
Advertisement
Electrical system
SPEED SENSOR
Whenever the speed is not indicated on the dashboard
and the message SPEED SENSOR appears, proceed
as follows:
• Check the conditions of the fuse in position 1 on the
fuse box.
E
If the fuse in question is in good condition, proceed
with the check of the speed sensor as follows:
Keeping the sensor connected to the system and with
1
2
3
4
the key ON, use a Tester to make sure that when the
5
6
7
sensor is placed in front of a tooth of the phonic wheel,
between terminal 3 and terminal 2 of the connector,
that the voltage is close to zero, whilst when it is not
placed in front of one of the nuts, the voltage is close
to that of the battery.
LOW BEAM HEADLIGHT
In the event that the dipping beam does not work,
check the conditions of fuse 3 on the fuse box. If this
fuse is ok, check the conditions of the relay situated on
the left side of the motorcycle, with the label "B".
If this condition is also met, check the continuity of the
R/B cable that goes from relay "B" to the engine con-
trol ECU to vehicle connector terminal C3.
- 31 -
Hide quick links:
Advertisement
Table of Contents
