Fitting The Fork Legs - MV Agusta F3 675 Workshop Manual

Screw the top cap assembly on the pumping rod until
it comes to a stop.
Keep in place the spring support (1) by using the pro-
per spanner (special tool) and tighten the lock nut to
the prescribed torque.
Torque pressure: 20 N•m
Apply prescribed grease on the top cap O-Ring and
threads.
Recommended grease: Ohlins Red Grease
(cod. 00146-01)
Fully extend the fork leg.
By using the special tool, screw the top cap into the
outer fork sleeve with the prescribed tightening torque.
Special tool No. 8000B6876
Torque pressure:10 N•m
Reassemble the stem taking care to pass the electrical

Fitting the fork legs

wiring, the clutch tube and and the brake pipe as
shown in the picture.
To ensure proper positioning of the rods, refer to the
figure at right, taking care to observe fitting dimension
"X":
- F3 675:
- F3 ORO:
Suspension and wheels
X = 216 mm
X = 216 mm
- 29 -
20 N•m
1
10 N•m
F