Table of Contents
Advertisement
Whenever the dashboard, with the switch on the ON
KEY SWITCH
position, is not powered, first check the conditions of
the fuse located on the starter relay and, if this should
be in good condition, check the conditions of the fuse
located in position 5 on the fuse box.
Check these two conditions, if the fault persists per-
form the continuity test according to the following table:
Key
Posizione
Position
Chiave
ON
OFF
E
e
P
A
R
K
TURN INDICATORS
If the blinker warning lights do not work, continuity
must be checked on the cable R-B between terminal 7
of the switch connector and terminal 9 of the dash-
board connector.
Check continuity between the G (green) - Bk/W
(black/white) wires for the Lh indicator and between
the G (green) - Y/W (yellow/white) wires for the Rh indi-
cator.
R.P.M. SENSOR
Engine rev information on the dashboard arrives by
means of a CAN line; therefore, if this information is not
displayed and the message CAN ERROR appears on
the dashboard, the problem can be attributed to the
dashboard.
Electrical system
Cables colour
Colore Cavi
R
G\W
Br\W
Br\Bk
O
O
O
O
O
O
O
O
- 30 -
Hide quick links:
Advertisement
Table of Contents
