Clamp Assembly - MV Agusta F3 675 Workshop Manual

Remove the anchoring from the steering head by
unscrewing the two screws (4) after they have been
heated, as described above.
During re-assembly apply Loctite 2700 to the two

Clamp assembly

screws (1) that clamp the anchoring to the head.
F
Tighten the screws to the prescribed torque pressure.
Assemble the counter-nut to the prescribed torque
pressure.
Threadlocking product used: Loctite 2700
Torque pressure: 8 N·m
Use Loctite strong threadlocker 2700 on the screw (2)
that secures the clamp to the anchoring.
Tighten the screw to the prescribed torque pressure.
Threadlocking product used: Loctite 2700
Torque pressure: 8 N·m
Suspension and wheels
- 42 -
4
1
8 N•m
2
8 N•m