MV Agusta F3 675 Workshop Manual page 348

Remove the protection cap of the bleed screw of the
caliper.
Introduce an 8mm wrench and connect the rubber tube
for collecting the brake fluid.
Holding the brake lever engaged, loosen the bleeder
screw and close it back up, all the while engaging the
brake lever.
Repeat the aforementioned operation 3 or 4 times.
H
Slowly squeeze the brake lever to bring the pads in
contact with the disc and also checking that there is no
sponginess in the action of the lever. Air bubbles
should not rise in the chamber.
If bleeding has been carried out correctly, the stroke
of the lever will be short and will not have an elastic
effect.
Otherwise, repeat the bleeding operations illustrated in
the points above.
Brakes
- 10 -